Shooting with Accuracy Shooting Tips 30 Round Magazine Assembly & Disassembly Markings Information Rear Sight - Zeroing Problems The M1 Carbine was designed primarily.

Disassembly: U. S. Rifle M1 Carbine. The U. S. Remove the magazine and open the Bolt to make certain there are no rounds in the rifle.

Unscrew the Barrel Band Screw. Depress the Band Spring  with a punch and use a non- marring hammer to tap the Barrel Band down the barrel. Microsoft Dns Server Debug Logging there.

Remove the Handguard up and out of the way. Remove the Receiver and barrel from the Stock by pulling up and then out. Drift out the Trigger Housing Pin with a punch. Remove the Trigger Housing from the Receiver by pulling straight back and then pulling away.

It’s also made of about a bajillion tiny parts. Grab a magnetic tray and some hand tools and we’ll try. The Russian-Soviet Mosin Nagant Model 1944 (M44) Carbine. From - Tuco Of Mosin-Nagant Dot Net.

Shooting a target @ 40 yards.

Pull back on the tip of the Recoil Spring Guide, compressing the Recoil Spring, and move it away from the recess in the Operating Slide. There is a notch along the Receiver that will allow you to release the Operating Slide.

Now push slowly forward on the Operating Slide while putting some counter- clockwise rotational force on it. Push the Bolt back all the way forward and in the locked position. Unscrew the Butt Plate Screw and remove the Butt Plate. Unscrew the Recoil Plate Screw and remove the Recoil Plate. You may press the Band Spring out of the stock with a punch from the left side. Hold the Hammer firmly and squeeze the Trigger.

Let the Hammer forward softly. Insert a punch with as close a diameter as possible into the hole at the front of the Hammer Spring Plunger. Use your punch to compress the Hammer Spring and move it left or right, away from the Hammer. Drift out the Hammer Pin and remove the Hammer. Drift out the Trigger Pin. Push the Trigger up and tilt back on it to disengage from the Trigger Spring and remove the Trigger from the gun.

Remove the Trigger Spring. Note the hole at the base of the Trigger Housing. Press the Magazine Catch to the right and remove it. Press on the left side of the Safety to drive it out. Your Trigger Housing is now disassembled. Death In Venice on this page. Let’s just look at this bolt first. Make room and get a white surface.

Using a small, flat screwdriver depress the Extractor Spring Plunger. Now drive out the Extractor.

Find the Extractor Spring Plunger. You may now simply pull out the Ejector and the Ejector Spring, the Extractor Spring, and the Firing Pin. Reassembly is just the reverse. This will require a balancing act.

Drift out the Slide Lock with a punch. Use a small punch or pin to fish out the Slide Lock Spring from the Operating Slide. Pick up the Barrel and locate the Gas Piston on the underside. Use a screwdriver or wide punch to unscrew the Gas Piston Nut. Remove the Gas Piston. You have now disassembled both the gas piston and the operating slide.

Section VI: The Sights. It is not recommended to remove the sights on an M1 carbine without specialty tools. Use a punch to drive out the Magazine Floorplate out of the front of the Magazine Body. Remove the Magazine Spring and Follower. Your magazine is disassembled.